Актуальные проблемы в машиностроении Том 4 №1 2017

14 / 142

Actual Problems in Machine Building. Vol. 4. N 1. 2017 Innovative Technologies
in Mechanical Engineering
____________________________________________________________________
14
8. Гаврюшин С.С., Барышникова О.О., Борискин О.Ф. Численный анализ элементов
конструкций машин и приборов. – М.: Изд-во МГТУ им. Н.Э. Баумана, 2014. – 479 с.
9. Böck H. The definitive guide to NetBeans Platform 7. – New York: Apress, 2012. – 558 p.
10. NetBeans Platform learning trail // NetBeans. – 2016. – URL:
(accessed: 28.02.2017).
11. Справочник технолога машиностроителя. В 2 т. Т. 2 / под ред. А.Г. Косиловой, Р.К.
Мещерякова. – 4-е изд. – М.: Машиностроение, 1986. – 418 с.
12. Справочник технолога-машиностроителя. В 2 т. / под ред. А.М. Дальского, А.Г.
Косиловой, Р.К. Мещерякова, А.Г. Суслова. – 5-е изд., перераб. и доп. – М.:
Машиностроение-1, 2001. – 912 с.
13. Гаврилова Т.А., Хорошевский В.Ф. Базы знаний интеллектуальных систем. – СПб.:
Питер, 2000. – 384 с.
14. Amador L. Drools developer’s cookbook. – Gardners Books, 2012. – 312 p.
15. Drools documentation // JBossDeveloper. – 2016. – URL:
(accessed: 28.02.2017).
INTEGRATED DECISION SUPPORT SYSTEM FOR THIN-WALLED PARTS CUTTING
CONDITIONS ASSIGNMENT
Zhargalova A.D. 1, Senior lecturer, e-mail:
Eremeykin P.A. 2, Post-graduate Student, e-mail:
1 Bauman Moscow State Technical University, 5 Baumanskaya 2-ya, Moscow, 105005, Russian
Federation
2 Mechanical Engineering Research Institute of the Russian Academy of Sciences, 4 Maly
Kharitonievskiy Pereulok, Moscow, 101990, Russian Federation
Abstract
This paper considers issues related to thin-walled parts processing. The authors pay attention to a
new “soft” processing modes approach, based on rational cutting modes assignment. The approach
takes into consideration the deformations occurring during processing. The paper highlights the
issues encountered in the automated system development and offers solutions with using modern
software and libraries. In addition, the article describes the technical ways to implement modular
structure and clarifies its composition. The authors indicate weaknesses of the system and measures
to eliminate it.
Keywords
lathing, deformation, thin-walled part, software development, numerical simulation, finite
element analysis (FEA)