Актуальные проблемы в машиностроении №2 2015

248 / 460

Actual Problems in Machine Building. 2015. N 2 Technological Equipment, Machining
Attachments and Instruments
____________________________________________________________________
248
12. Чёсов Ю.С. Кинематический расчет привода главного движения металлорежущих
станков : учеб. пособие. – Новосибирск: Изд-во НГТУ, 2013. – 80 с.
13. Пуш В.Э. Конструирование металлорежущих станков. – М.: Машиностроение,
1977. – 392 с.
A TECHNIQUE OF MEASURING THE DRIVE POWER OF THE MAIN MACHINE
TOOL MOTION
Chesov Yu.S., Ph.D. (Engineering), Associate Professor, e-mail:
Ptitsyn S.V., Associate Professor, e-mail:
Zverev E.A., Ph.D. (Engineering), Associate Professor, e-mail:
Suharev V.O., Master’s Degree student, e-mail:
Tsybenko M.S., Master’s Degree student, e-mail:
Novosibirsk State Technical University, 20, Prospect K. Marksa, Novosibirsk, 630073, Russian
Federation
Abstract
A technique for measuring drive power losses of the main turning lathe motion and the
calculation of its efficiency are considered. In addition, analog-to-digital converters equipped with a
set of sensors to measure the necessary parameters to be then transmitted to a computer is proposed
instead of pointer-type instruments usually used in laboratory facilities. This will improve the
accuracy and reliability of measurements as well as significantly reduce the complexity of data
processing.
Keywords
technique of measuring; drive power; no-load losses; load losses; effective power; coefficient of
efficiency